Replace front brake pads and machine front rotors. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle.
Replace rear brake shoes. Replace rear wheel cylinders, Resurface rear brake drums. Clean, lubricate backing plates and reassemble. Bleed air from system. Road test vehicle.
Mark B. gave our service a 5 star review on 5/14/2025
PCM code P0430 Catalytic converter efficiency low bank 2, Will need the catalytic converter replaced. ABS codes C1201 Engine control system fault. (See above) C1223 Fault injABS system. C1252 Hydroboost pump motor fault. C1256 Accumulator low pressure fault. C1336 Yaw rate sensor fault. Brake inspection: Front Pads (4mm) Rear pads (gone). Rear brakes had been metal to metal for so long that one inside pad fell out. All of the brake fluid leaked out. Need to replace rear brakes w/ new (re-manufactured) calipers and new rotors.
Replace rear brake pads, calipers and machine rear rotors. Lubricate new brake caliper slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle.
Bleed entire brake system and re calibrate the yaw sensor.
Shambre G. gave our service a 5 star review on 5/7/2025
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic inspection. Road test vehicle. Reset Maintenance Light if Applicable.
Found that nothing would work until the window was rolled up once. Window stopped again when hatch was opened half way. Took the harness apart and could find no broken wires in the boot. Also could not duplicate the failure again. May need to replace the rear glass motor and module.
Removed and replaced the left low beam headlight bulb. Removed and replaced left daytime running light. Removed and replaced the left inner tail light bulb.
Greg S. gave our service a 5 star review on 4/16/2025
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic inspection. Road test vehicle. Reset Maintenance Light if Applicable.
Rotated the tires. Brakes Remaining Front (8mm) Rear (8mm)
Remove and replaced the cabin air filter. Clean any debris from the heater box.
Remove and replace worn wiper blades with new wiper blades.
Removed and replaced the serp. belt.
Carol H. gave our service a 5 star review on 4/4/2025
Check PCM with Scan Tool. Code # P0016 Camshaft timing misalignment at idling ( bank 1 intake ). Check the oil condition and level. Use can tool to actuate the VVT and the test responding good. Clear the code and test drive the vehicle. No code come back and vehicle runs good. Did not find any thing related it to check engine at this time. The only thing we can recommend is replacing the VVT oil control filters and the oil control solenoid for bank one intake.
Remove and replaced the vvt oil control valve bank one intake.
R&R both valve cover gaskets to replace the VVT oil control filters.
Julie D. gave our service a 5 star review on 1/10/2025
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic inspection. Road test vehicle. Reset Maintenance Light if Applicable.
Rotated the tires. Brakes Remaining Front (6mm) Rear (5mm) Tread remaining Front 8/32 Rear 9/32
Raymond O. gave our service a 5 star review on 12/20/2024
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic inspection. Road test vehicle. Reset Maintenance Light if Applicable.
Herb D. gave our service a 5 star review on 11/14/2024